Interfaces 1 and 2
The HSM has two network ports, named 1 and 2, which can be used independently or aggregated. When used independently, the IP address and mask are configured here. When the ports are configured to Bond, ports 1 and 2 become Slaves and the status of the ports is shown here.
The IP address must be entered in dot-decimalnotation, for example 207.142.131.235. The netmask can be entered in dot-decimal or CIDR notation, for example /24, but is always displayed in dot-decimal notation.
The MAC Address of the HSM interface and the status and speed of the link are shown on this screen.
After entering the values, use the Update button to activate the change. If there is any error or inconsistency in the entered data, an update failure message will be displayed.
Dinamo - Local Management Console
┌──────────────┤ Interface 1 ├──────────────┐
│ │
│ IP Address _______________ │
│ │
│ Network mask _______________ │
│ │
│ MAC Address 02:42:AC:11:00:02 │
│ │
│ Link up, auto neg on, 1000Mb/s, FD │
│ │
│ ┌────────┐ ┌───────┐ ┌───────┐ │
│ │ Update │ │ Speed │ │ Close │ │
│ └────────┘ └───────┘ └───────┘ │
│ │
└───────────────────────────────────────────┘
Service running... Replication Domain: <none>Network settings are changed immediately after confirmation via the Update button.
The HSM leaves the factory configured for network speed auto-negotiation. In the Speed option you can change the speed and force a specific mode, including choosing between Half Duplex and Full Duplex.
Dinamo - Local Management Console
┌─────┌──────────────┤ ├──────────────┐────┐
│ │ │ │
│ IP│ Auto-negotiation : off │ │
│ │ Speed : 1000Mb/s │ │
│ Ne│ Duplex : Full │ │
│ │ │ │
│ MA│ ┌────┐ │ │
│ │ │ OK │ │ │
│ Li│ └────┘ │ │
│ │ │ │
│ ┌│ │ │
│ │└────────────────────────────────┘ │
│ └─ │
│ │
└───────────────────────────────────────────┘
Service running... Replication Domain: <none>