Skip to content

First time

Step by step

  1. Run DINAMOcon and click the First time button on Pocket to start the settings.

    The Remote Management button can also be used when Pocket is in its factory state.

    Finding Pocket on the net Finding Pocket on the net
    Finding Pocket on the net

  2. Select your DINAMO Pocket and click OK.

    If pocket does not appear in the list, it is probably on a different network or subnet. pocket is factory-configured to start the network via DHCP. If there is no DHCP server available, you will need to configure an IP address manually (see Physical Description).

    Note

    To make sure you are connecting to the correct device, check the serial number displayed (example DPGL17010100) and compare it with the serial number located at the bottom of your DINAMO Pocket .

    If 2 IPs appear for the same serial number, IP 192.168.243.1 can be ignored. After the firmware update it will not appear again.

  3. After connecting to your Pocket, it will enter a tutorial for first-time use. Read the information and continue.

    Tutorial Pocket Tutorial Pocket
    Tutorial Pocket

  4. It is necessary to create Initialization Password.

    Read the message carefully, enter your password and confirmation and continue.

    Attention

    This password is your guarantee of privacy for the keys stored on Pocket. It will be required whenever Pocket is turned on and during certain critical operations. If you lose this password, you may not be able to use the equipment.

    For your convenience, a file will be generated in your private Windows documents folder HTML (Ex: pocket_init_password_DPHL17010000.html) with the boot password. The generation of this file can be disarmed via the checkbox on the screen.

  5. If the version of pocket is lower than the version 5 an update process is automatically started (see section Outdated units). Then the step-by-step is resumed.

  6. The next step is to set the user's password master of HSM. This part is optional but highly recommended, read the text carefully and continue. If you don't change it, the default password is 12345678.

  7. This part is also optional, for registering and authenticating at Dinamo Cloud. If you want to configure this now, just read the text on the screen and follow the instructions.

  8. Your Pocket is now ready for use. Remember that a Initialization Password and a password for the user master. They have different functions and both will be needed when operating the device.

  9. Set up an hsm user so that the applications can connect to the HSM. On the main screen, click on Local configuration and the HSM tab configures the IP address, user name and password credentials that will be used by the libraries (MS CAPI, PKCS#11, Engine etc) and also for managing certificates.

    HSM tab HSM tab
    HSM tab

Outdated units

  1. If the version of pocket is lower than the version 5 an update process is automatically started. Simply click on the "Start update" button.

    Start of update Start of update
    Start of update

  2. Then the update package will start downloading, just wait.

  3. At the end of the download, confirm the update.

  4. When the update is complete, you will need to restart DINAMO Pocket to finish, click on Yes.

  5. Wait for the reboot process. It may take several minutes (about 06 min).

    Waiting for Pocket to restart, it may take several minutes Waiting for Pocket to restart, it may take several minutes
    Waiting for Pocket to restart, it may take several minutes

  6. After restarting, you need to authenticate, click OK.

  7. Enter the Startup Password to authenticate at pocket and click OK, as shown in the image.

  8. After updating and authenticating, the continue button will activate, continue step by step.