Service start
Starts and stops the HSM service.
If there are active client sessions before the HSM attempts to stop the service, a warning message is displayed asking you to confirm or cancel the operation. If the operation to stop the service is confirmed, the HSM will immediately disconnect all client sessions. This process should take between 30 and 60 seconds. While trying to stop the service, the local console cannot be used.
Once the service stop operation has started, new client sessions can no longer be established.
The menu option will be Start or Stop depending on the service status of the HSM.
Dinamo - Local Management Console
┌──────────────────┤ ├──────────────────┐
│ │
│ Are you sure you want to stop service? │
│ │
│ ┌────┐ ┌─────┐ │
│ │ No │ │ Yes │ │
│ └────┘ └─────┘ │
│ │
│ │
└────────────────────────────────────────┘
Service running... Replication Domain: <none> Dinamo - Local Management Console
┌─────────────────────────────┤ ├─────────────────────────────┐
│ │
│ System detected 1 active session(s). │
│ │
│ Warning: clean service stop can only be accomplished │
│ after all sessions are closed. You can check Active Sessions │
│ on Monitor Menu. │
│ │
│ If you continue system may have to wait up to 36 seconds. │
│ │
│ Continue anyway? │
│ │
│ ┌────┐ ┌─────┐ │
│ │ No │ │ Yes │ │
│ └────┘ └─────┘ │
│ │
│ │
└──────────────────────────────────────────────────────────────┘
Service running... Replication Domain: <none>